Chosen Solution
Hi all,I recently replaced my MacBook’s battery with a replacement part from iFixit EU. I installed the battery just fine and it seems to work ok for the most part. However, when my battery pack reaches about 2-3% the macbook turns off entirely and when I plug it in, let it sit for a bit and hit the power button the laptop boots up like if it was powered off, with all the apps reopening from the beginning.I would normally expect that it would enter hibernation mode and pick up right where I left off when it ran out of battery, like it used to do with the factory one, but that is not the case. I followed the calibration procedure, reset my SMC and followed the calibration again. I also checked the nvram and hibernatemode is set to 3, meaning that it should in fact enter hibernation mode.I’m at a loss here. Any advice welcome. TIA.Edit: Image requested by Dan
Did you follow the calibration steps? As that is important so SMC knows the high and low states. Update (01/10/2023) @devnol @devno This is all I see. The charge is very low and the charger is not plugged in so you are in discharge!
